Design Process

-

 I have just created a page where I discuss the design process I'm following to complete this project


It's not without its costs in terms of failed attempts, but I am determined to get to the best design for each element! 

Please see the specific page here. 


Visit the main content pages

Comments

Post a Comment

Popular posts from this blog

New release: Mount for TFT35 finally complete

-
Image
I have today completed the design of my mount for a Bigtreetech TFT35 V3 which I have chosen as the new touch display to replace the standard LCD.  I have been through a few iterations with this one (and then some) trying to get the size as compact as possible and the design as clean as I could. I'm really quite pleased with the results.  Read more about it in my information page here .  Although it's not yet fully released, I've also been tweaking the case design for the SKR 1.4 main board. Today I added a slot into the lid to fit the external EEPROM module I'm using. It's currently loose on a cable, but it now has a home (or will have when I've printed it).  Visit the main content pages
Read more

SKR1.4 and TFT 35 - using long file names and print from SKR SD card

-
Image
This is a bit of a diversion from the rest of the blog, but it's relevant as it's on the same path. I felt it might be helpful to post this as I'd tried, unsuccesfully, to find a definitive answer elsewhere so got there by trial and error.  If you have an SKR 1.4 mainboard coupled to a BTT TFT35 (NB I suspect that this will also be relevant to other combinations of MB and TFT) and want to Enable long filename support Add the MB SD card as a print source This is what I had to do to get this working. There are two areas which need to be changed  CONFIG.INI on the TFT CONFIGURATION_ADV.H on the Marlin (2.X) build This solution is based around my configuration but is likely to be more generic, I think. I am running SKR 1.4 Turbo - Marlin 2.0.5.3 BTT TFT35 V3.0.26 Change Marlin Firmware You will need to create a new build, with the following changes in the configuration_adv.h file. First, you need to enable the onboard SD card as Then, to enable the long filenames change:  Re...
Read more

Update: delayed but not forgotten

-
Those of you following this blog will have noticed that I've gone a little quiet for a while. This is due to a combination of factors. First, I am very busy with work at present and, secondly, I have a backlog of things which I need to print for jobs around the house. I can't print with the printer at the same time as rebuilding it. To give an update on progress: I still need to rejig the X-axis cable chains to rotate them by 90° The fanless PSU seems to be working very well indeed and makes a huge difference to the noise of the printer The foam insulation on the base of the HBP also seems to help a lot and works far better than I'd expected. Heat up time is improved significantly and excess cooling between prints is also reduced.  I have a set of Z axis pull-rods to install for extra rigidity but these need to be modded to fit the 350mm Z height.  I also really want to move to the latest version of Marlin to address a few annoying niggles which I know are present in 2.0.5....
Read more